Representative image · Sencronom
Vacuum and process consumables · Release Film
PMP Release Film
Light, heat-resistant pink film for a wide range of parting uses.
RF-M204
- Operating range
- ≤ 204 °C≤ 399 °F
- Elongation at break
- 285%
- Thickness
- 30µm1.18mil
Technical properties
| Parameter | Value | Condition |
|---|---|---|
| Mechanical | ||
| Elongation at break — MD | 285% | direction not stated |
| Physical / dimensional | ||
| Thickness | 30µm1.18mil | |
| Color | Pink | |
| Flow / permeability / absorption | ||
| Perforation type | Perforated or non-perforated | |
| Chemical / surface | ||
| Resin system compatibility | Epoxy, Polyester, Vinyl ester, Phenolic | |
| Process / commercial | ||
| Process compatibility | Oven cure, Vacuum infusion, Autoclave | |
| Other | ||
| Material | Modified PMP (polymethylpentene) | |
Where it sits in the vacuum bag
The vacuum bag from mould to bag, with the layers each method uses. Hover over a layer or pick one from the list.
Method
4Release filmThis productKeeps the upper layers off the laminate; perforated grades let excess resin through.
Layers, top to bottom
Numbers show the layup order.
Representative layup; layers vary with the method and the part.
Operating range
≤ 204 °C≤ 399 °F
032100212200392300 °C572 °F
- Maximum service temperature
- 204°C399°F
Method suitability
- Oven cureSuitableSuitable for Oven cure
Does not stick to the part even at high temperature.
- Vacuum infusionSuitableSuitable for Vacuum infusion
Does not stick to the part even at high temperature.
- AutoclaveSuitableSuitable for Autoclave
Does not stick to the part even at high temperature.
Supply and storage
- Resin compatibility
- Epoxy
- Polyester
- Vinyl ester
- Phenolic
- Packaging
- Roll
- Storage
- In a cool, dry area
Alternatives in this group
Release Film · Differences are relative to this product.
| Compare | Product | T max °C°F | Elongation at break | Thickness | Width | Oven | Infusion | Autoclave | Product page |
|---|---|---|---|---|---|---|---|---|---|
| Perforated Polyethylene Release FilmRF-P120 | 120°C248°F−84−151 | 560%+275+275 | 25µm0.98mil−5−0.2 | 1550mm61in | Suitable for Oven cure | Suitable for Vacuum infusion | Not used with this method | ||
| PMP Release Filmthis productRF-M204 | 204°C399°F | 285% | 30µm1.18mil | – | Suitable for Oven cure | Suitable for Vacuum infusion | Suitable for Autoclave | ||
| ETFE Release FilmRF-E260 | 260°C500°F+56+101 | 350%+65+65 | 25µm0.98mil−5−0.2 | 1220mm48in | Suitable for Oven cure | Suitable for Vacuum infusion | Suitable for Autoclave |