Representative image · Sencronom
Fibers & cores · Foam Core
PVC Foam Core 80 kg/m³
Lightweight closed-cell core that adds stiffness to sandwich structures. Grooved and perforated cuts are available for infusion. Stay below the maximum processing temperature.
CR-P80
- Operating range
- ≤ 80 °C≤ 176 °Fpeak 100 °Cpeak 212 °F
- Density
- 80kg/m³4.99lb/ft³
- Thickness
- 5–40mm0.197–1.57in
- Sheet size
- 1220 × 2440mm48 × 96.1in
Technical properties
| Parameter | Value | Test method |
|---|---|---|
| Physical / dimensional | ||
| Thickness | 5–40mm0.197–1.57in | |
| Density | 80kg/m³4.99lb/ft³ | ISO 845 |
| Sheet size | 1220 × 2440mm48 × 96.1in | |
| Chemical / surface | ||
| Resin system compatibility | Polyester, Vinyl ester, Epoxy | |
| Process / commercial | ||
| Process compatibility | Vacuum infusion | |
Do not exceed the max temperature if a heated post-cure is planned.
Where it sits in the vacuum bag
The vacuum bag from mould to bag, with the layers each method uses. Hover over a layer or pick one from the list.
MethodVacuum infusion
2LaminateThis productReinforcement fabric and resin: the part itself.
Layers, top to bottom
Numbers show the layup order.
Representative layup; layers vary with the method and the part.
Operating range
≤ 80 °C≤ 176 °F
03250122100212150302200392250 °C482 °F
- Maximum service temperature
- 80°C176°F
- Short-term peak temperature
- 100°C212°F
Method suitability
- Oven cureNot used with this method
- Vacuum infusionSuitableSuitable for Vacuum infusion
The grooved cut carries resin under the core as well.
- AutoclaveNot used with this method
Supply and storage
- Resin compatibility
- Polyester
- Vinyl ester
- Epoxy
- Packaging
- Sheets on a pallet
- Storage
- Flat, on a dry surface, out of direct sunlight